Operation Manual
*#1 :-Owner’s Manual
58
CONTROL
In this mode, you can do the setting relating to each
controller.
You may change the roles of several knobs and switches
mounted on this keyboard. Also, on the rear panel are
two terminals for connecting the Foot-switch and the
Expression Pedal. You must choose either of them in this
mode.
To locate this mode:
1. Touch the [MENU/EXIT] button and display the MENU and
select PAGE A by the [PAGE] button, and then touch the
[4] CONTROL button.
2. Or, you may touch the [CONTROL] button (in default).
MOTOR
There is no pitch-bend function on the B-3/C-3.
So some musicians turned off the power while
playing in order to get that effect.
If the B-3/C-3 is turned off, the Tone-wheel
motor gradually slows down and stops, and the
amplifier does as well. This function is to
simulate that on this model.
PITCH BEND
1. BEND - L&U DOWN (P)
2. BEND - L&U UP (P)
3. BEND - PEDAL DOWN (P)
4. BEND - PEDAL UP (P)
These are for setting the changing range of the PITCH-BEND WHEEL by the semi-tone.
Both the LOWER and the UPPER PARTS change at the same time, as they use the same
Tone-Wheels.
The setting range is 0 - 12 for up, 0 - 24 for down.
5. BEND - MODE (P)
It switches the function of the PITCH BEND wheel.
BEND:
You can slide the pitch by rotating the PITCH BEND wheel.
MOTOR:
You can control the TONE-WHEEL motor. The motor turns on when it is in the
center or in the neutral position, stops when you rotate it forward (toward
yourself), and accelerates when you push it back.
6. BEND - TIME (P)
This sets the time for slowing down to stop or accelerating the motor when it [=
MODE(5)] is in the MOTOR mode.
The value ranges from 0.1[s] to 5.0[s].
7. BEND - AMPLIFIER (P)
This decides whether to turn off the amplifier or not by rotating the PITCH BEND wheel
forward (toward the player).
HOW PITCH BEND MODE WORKS
BEND: The pitch immediately falls.
MOTOR: The pitch gradually falls down to the
set point.
19
1
16
11109
2 3 4 5 6 7
8
15
18
141312
17
10