Operation Manual

Setting the Parameters

5. HORN LEVEL

12. BASS LEVEL

The Volume of each Rotor is set. The setting range is 0 to -12dB.

6. RISE TIME - HORN

13. RISE TIME - BASS

Here the Time is set for the Rotor to reach the Fast Speed, when you go from

Slow or Break to Fast. The setting range for the Horn Rotor is 0.2 - 5.0s, and

that for the Bass Rotor is 0.5 - 12.5s.

7. FALL TIME - HORN

14. FALL TIME - BASS

Here the Time is set for the Rotor to reach the Slow speed, when you go from

Fast to Slow Speed. The setting range for the Horn Rotor is 0.2 - 5.0s, and that

for the Bass Rotor is 0.5 - 12.5s.

8. BREAK TIME - HORN

15. BREAK TIME - BASS

Here the Time is set for the Rotor to stop, when you go from Fast state to

Break. The setting range for the Horn Rotor is 0.2 - 5.0s, and that for the Bass

Rotor is 0.5 - 12.5s.

9. HORN CHARACTER

Here the Tone of the Horn Rotor is set.

"FLAT" is a flat tone, and the others are the tones with each "peaky" character-

istic.

16. MIC - ANGLE

This is the parameter to set the LOCATIONS of the two Microphones for the

imaginary Leslie Speaker.

The ANGLE decides the distance between the two mikes.

The setting range is 0 - 180 degrees. The farther, the more stereophonic feeling

it gives.

17. MIC - DISTANCE

This is the parameter to set the DISTANCE between the imaginary Leslie

Speaker and the Microphones.

The setting range is 0.3 - 2.7m. The more the value increases, the less effective

it gets.

NOTE: When you operate the parameters 2 - 17, the setting range will be lost

after the power is switched off, if you do not do the recording operation

of the next page.