Operation Manual

*#1 :-Owner’s Manual

EQUALIZ (EQUALIZer)

In this mode, you can change the setting for the Equalizer.

Equalizer is an effect to adjust the tonal quality. The built-in Equalizer consists of

3 bands. With the 3 bands from bass to treble, you can boost or cut them.

To locate this mode:

1. Touch the [MENU/EXIT] button for the MENU, select PAGE C by the [PAGE] button, and

then touch the [2] EQUALIZE button.

2. Touch and hold the [TONE TYPE] button.

1. EQ BOOST/CUT - BASS

2. EQ BOOST/CUT - MIDDLE

4. EQ BOOST/CUT - TREBLE

This is for changing the Boost/Cut of Bass, Mid-range and Treble respectively.

The setting range is -9 to +9. The gain is flat at 0.

3. EQ FREQUENCY - MIDDLE

This is for changing the center frequency range - Middle (item #2).

The frequency center range is 480Hz - 2.9kHz.

5. TONE - ASSIGN

This function allows you to assign any of the EQ bands, Bass, Middle or Treble, to the

[TONE] knob. You can change this while playing.

NOTE: These parameters are Preset Parameters and are recorded to each Combination

Preset.

PRESET PARAMETERS

Equalizer is a Preset Parameter, designed to

actively use as one of the tone-making

parameters.

However, it is not practical to use Equalizer as a

tonal complementary tool to match the location.

In such a case, if you switch OFF the P.LOAD RV/

EQ in the PRESET function mode, the Equalizer

value does not change when the preset is

recalled. (P. 56)

THE EFFECTIVE USE OF THE MIDDLE

FREQUENCY

The frequency response of the horn rotor in the

Leslie speaker is not flat. It has a peak from

1kHz to 3kHz that sensitive range for human

ears.

When you use this keyboard on line out, without

Leslie speaker, you can get the similar effect by

setting the FREQUENCY - MIDDLE to about

2kHz, and the GAIN - MIDDLE to "+".

3 4