Operation Manual

*#1 :-Owner’s Manual
80
RECORDING AND PLAYING
This is the method to record and playback your performance, by connecting the
Sequencer or Computer to your XK-1.
1. Hook up as illustrated.
Connect the MIDI OUT to the MIDI IN of the Sequenser.
2. Recall “Seq. Record” by using a MIDI template.
By this, the output of the XK-1 is sent to MIDI channels 1, 2 and 3.
3. Set the Keyboard Channel if you want.
4. Start the Sequencer recording.
5. Send the Memory Dump if you want.
6. Start playing.
NOTE: If the MIDI Keyboard is connected to the MIDI IN terminal of this keyboard, these perfor-
mance information will be transmitted to each MIDI channel and sent out of the MIDI OUT
terminal.
1. Hook up as illustrated above.
If a MIDI keyboard is connected, unplug it and connect the MIDI OUT of the Sequencer to
the MIDI IN of this keyboard.
2. Recall “Seq. Play” by using a MIDI Template.
By this, the messages received at the MIDI Channels 1,2 and 3 are distributed to each Part.
3. Setup the Keyboard Channel if necesary.
4. Start Playback on the Sequencer.
 Only the built-in sound source can be recorded. The control of the Exter-
nal Zone is not played back.
Recording to the Sequencer or the Computer
Playback from the Sequencer or the Computer
MIDI Keyboard
MIDI Pedal
Keyboard
MIDI Keyboard
MIDI Pedal
Keyboard