Operation Manual
*#1 :-Owner’s Manual
88
TROUBLE SHOOTING
Malfunction of the buttons, the keys, etc.
Turn off the POWER switch once, then turn it on again. If this procedure is not
successful, turn off the POWER switch once. Then, while pressing [REC/JUMP]
button, turn the POWER switch on again. (Note that, in this case, all parameters
return to their factory-preset status.)
Malfunction of the Combination Presets.
The Display is in MENU or any FUNCTION modes.
Go back to PLAY mode by touching the [PLAY] button.
No sound is produced when the keys are pressed.
The MASTER VOLUME is at the minimum setting. Adjust the volume with
the MASTER VOLUME control. (P. 10)
The LOCAL CONTROL is set to OFF. Set the local control to ON. (P. 84)
Expression does not change.
The EXPRESSION - SOURCE is not the correctly set. Set the EXPRESSION -
SOURCE in the “CONTROL” screen correctly. (P. 59)
The sound is distorted.
The sound is distorted not as the [OVERDRIVE] knob screen shows.
If you are playing this keyboard using the Combination Preset, the actual value
of the drive is different from the position of the knob.
Turn the [OVERDRIVE] knob to the left, to the point where it is not distorted.
The sound does not come out immediately after switched
on.
The [TUBE AMP] button is ON. A Vacuum Tube circuit is mounted in this
keyboard. It takes approximately 10 to 20 seconds after the [TUBE AMP] but-
ton is switched ON. Before you will hear the sound.
The sound is not distorted if the [OVERDRIVE] knob is
turned.
When the Overdrive Expression is at “EXJOD” or “OD ONLY”, it does not
distort if the value if the Expression is low. In such a case, increase the Expres-
sion value, or, set the Overdrive Expression at “ODJEX”, if you want to distort
regardless of the Expression value. (P. 69)
The sound stops upon changing the Combination Preset
during playing.
This keyboard stops the sound when the some parameter has changed that listed
below;
Internal Zone - Key Range, Ocatave
Tone-Wheel set
Reverb Type (reverb sound only)