Operation Manual

*#1 :-%Owner’s Manual
106
TROUBLE SHOOTING
Malfunction of the buttons, the keys, etc.
 Turn off the POWER switch once, then turn it on again. If this
procedure is not successful, turn off the POWER switch. While
pressing [REC/JUMP] button, turn the POWER switch on
again. (Note that in this case, all parameters return to their
factory-preset status.)
No sound is produced when the keys are pressed.
 The MASTER VOLUME is at the minimum setting. Adjust the
volume with the MASTER VOLUME control. (P. 10 #1)
 The LOCAL CONTROL is set to OFF. Set the local control to
ON. (P. 96 #3)
 The SEND terminal is plugged in. Use RETURN terminal for
return signal. (P. 16)
Expression does not change.
 The EXPRESSION - SOURCE is not correctly set. Set the EX-
PRESSION - SOURCE in the “CONTROL” screen correctly.
(P. 64 #10)
The Foot Switch does not work.
 The Foot Switch settings are not correct.
Reset the Foot Switch correctly in the CONTROL mode. (P. 64
#16)
The sound is distorted.
 The sound is distorted not as the [TUBE OVERDRIVE] knob
screen shows.
If you are playing this keyboard using the Combination Preset,
the actual value of the drive is different from the position of the
knob.
Switch OFF the [TUBE AMP] button, or, turn the [TUBE OVER-
DRIVE] knob to the left, to the point where it is not distorted.
You can easily check the actual drive value by the [TUBE AMP].
(P. 39)
 Depending on the headphones you use, the sound is sometimes
distorted when you turn the [MASTER VOLUME] to the maxi-
mum. In such a case, set the [MASTER VOLUME] in the middle.
The sound does not come out immediately after
switched on.
 The [TUBE AMP] button is ON. A Vacuum Tube circuit is
mounted in this keyboard. It takes approximately 10 to 20 sec-
onds after the [TUBE AMP] button is switched ON before you
will hear the sound.
The sound is not distorted if the [TUBE OVER-
DRIVE] knob is turned.
 When the Overdrive Expression is at “EX-OD”, it does not dis-
tort if the value of Expression is low. In such a case, increase the
Expression value, or set the Overdrive Expression at “OD-EX”
if you want to distort regardless of the Expression value. (P. 78
#5)
 How to set the Velocity:
 The built-in sound engine of this organ corresponds only to the
velocity of the Percussion and the Pedal parts, and not to that of
the Drawbars of the Upper or the Lower parts.
Refer to P. 57 #14 for setting the Pedal part and P. 71 #6 for
setting the Percussion.
 How to transpose:
 You can transpose within the range of 6 upper and lower semitones,
and change the Master-tune in the range of A = 430 - 450Hz.
Refer to P. 67 for details.
 The status of the External Speaker does not
change, if switching ON the [BRAKE] button.
 Some Leslie Speaker models do not [BRAKE]. [BRAKE] is pos-
sible on 2101/2102, 122XB and 3300 (current models).
 Audio is interrupted when a Combination Preset
is selected.
 Between the Combination Presets with different Tonewheel
Settings, the sound will be cut off while the Tonewheel Set-
tings are switched.
 Because the sounding systems must be switched between the
Combination Presets with different values of the Percussion
velocity, no sound comes out until another key is touched.