Operation Manual

*#1 :-%Owner’s Manual
14
EFFECT LOOP
51. SEND
This jack is for sending to external Effects.
The signal after passing through the built-in Tube Amp. is sent
out.
If you insert a plug into this jack, it disconnects the internal unit,
and signals are not put out from the output jack, except the sig-
nal input from RETURN jack.
(The rated output level is 1.23V +4dBm. The output impedance
is 600Ω.)
52. RETURN/EXT IN
This jack is for receiving external Effects.
This jack can be used as the input jack of a external sound source.
(The rated input level is 1.23V +4dBm. The input impedance is
10kΩ.)
NOTE: Depending on the connected equipment, a setting may
be required for the RETURN jack. (P. 83)
SOUND OUTPUT TERMINAL
53. LINE OUT L/MONO
If your amplifier has only a single (1) female 1/4” audio input
connector (MONO input), use this Jack.
54. LINE OUT R
This is the Right channel output of the XK-3C.
Use the Left and Right output Jacks if your mixer or amplifier
has stereo input.
Use only the L/MONO terminal, if the input is monaural.
The built-in Leslie Effect is only on L (the left), when the Leslie
Speaker (56) is connected.
55. HEADPHONE
This is for connecting the stereo headphones.
Sound is sent out from the LINE-OUT (53, 54) and LESLIE 11PIN
(56), also when this terminal is used.
The built-in Leslie Effect is only on L (the left), when the Leslie
Speaker (56) is connected.
56. LESLIE 11PIN
This is for connecting the Leslie Speaker.
Read “CONNECTING THE LESLIE SPEAKER” for more de-
tails.
51 52 55 565354