Operation Manual

*#1 :-%Owner’s Manual

HOW TO POWER ON

After connecting your XK-3C to the power outlet, please perform the following steps before switch-

ing on the power. To avoid possible damages to speakers, please do not change the order of the steps.

STEPS TO TAKE

1. Set the MASTER VOLUME Knob at 0 (minimum), before switching the power on.

2. Switch on the POWER on the rear panel. “PLAY” Mode appears, following the TITLE, in the

Display window.

 It takes a few seconds before the XK-3C gets ready, because of the circuit-protection

devices.

 It requires 10 to 20 seconds to warm up the tubes to get ready, when the [TUBE AMP]

Button is ON.

3. Switch on the power of the amplifiers etc. connected to the XK-3C.

4. Holding down a key, adjust the MASTER VOLUME by turning the Knob.

 The Preset Key [B] does not produce sound when initially first turned on. Draw the left

Drawbar(s), or press either of the Preset keys [C

] - [A] to start.

5. Adjust the volume of the amplifiers etc.

 Reverse the above steps when you switch off the power. (Switch off the power of the

amplifiers etc. first.)

BACK-UP

Your XK-3C memorizes the setting of the keyboard immediately before it is switched off. So, The

keyboard will start with these settings when it is switched on again. This is called “Back-up”.

The XK-3C is initially shipped from the factory with the Preset Key [B] in “pressed” status.

RESET TO THE INITIAL STATUS

Please perform the following steps to reset the XK-3C to the initial default setting.

STEPS TO TAKE

1. Switch off the power of the XK-3C.

2. Holding the [REC/JUMP] Button, switch on the power.

3. Hold down / Keep pressing the [REC/JUMP] Button until “Loading Default...” appears on the

Display.

4. If everything is in order, PLAY Mode appears on the Display. (Completed)

POWER ON

RESET FOR XK-SYSTEM

If you want the Upper and Lower manual Reverse color Presets to function just like they do on B-3/

C-3 organ when using the XK-System, follow the above procedure except in step 2 press the [BANK]

instead of [REC/JUMP].

Initial Preset Bank is [B] (refer to Factory Presets), Preset Load (P. 58) works only for Drawbar

registration, Preset - Link Lower / Pedal is “Off”, and MIDI IN mode (P. 96 #2) is “Lower / Pedal”.