Operation Manual

Setting Up

TUBE AMP

The TUBE (= Vacuum Tube) AMP produces a unique “Tube Feeling” sound.

By changing the amount of the Drive, various Tube Sound is obtained, from the

unclipped clean to the hard-distorted fuzzy, raspy Overdrive sound.

[TUBE AMP] BUTTON

This is for determining whether or not to go through the Tube Amp circuit.

To get this effect, touch the button and and the LED will light.

NOTE: You can see the tube through the ventilation hole on the back.

[TUBE OVERDRIVE] KNOB

This is for adjusting the distortion value of the Tube Amp circuit.

It does not clip, if turned to the left all the way, but the tone quality is slightly different

from when the [TUBE AMP] button is OFF, because it passes through the Tube Amp cir-

cuitry.

As you turn it to the right, the distortion value increases, and the color of the LED of the

[TUBE AMP] button changes from green to red, in accordance with the amount of distor-

tion.

NOTE: You can fine-set the distortion degree. (P. 78)

TUBE AMP CIRCUIT

Tubes are rarely used in modern electric

apparatuses but because semi-conductors

are better characteristics and because

tubes are inferior in many aspects.

However, in some areas, tubes are again

popular because of their specific charac-

teristics, which are produced only by tubes.

People are still searching for the sound

simulating that of tubes for effectors.

In this keyboard, a real Tube circuit is used.