Operation Manual

Using the Control Panel
53
Decrease the value, using the [VALUE] button or the [VALUE] knob
on the right bottom.
NOTE: Repeat the operation 1 - 5, if you want to change the other param-
eter, too.
Record into the Combination Presets.
The “DECAY FAST” is a Preset Parameter, it will go back to the set value, if you
call out the other (or current) Combination Preset.
If you want to continue to use the changed value hereafter, you must record the
value into the Combination Preset.
PRESET PARAMETERS
They are the Parameters to be recorded into
each Combination Preset.
They include the Parameters for setting the
status of the buttons/knobs on the panel,
“Decay Fast” and many others.
The overall/general common Parameters
(which are not included in the Combination
Presets) are called “Global Parameters.”
Move the CURSOR to the Parameter you want to change.
DECAY TIME is on the “DECAY” PAGE. Move to that page using
the [PAGE] button.
“FAST” is on the right end. Move the CURSOR (flashing value) to
underneath “FAST” using the [PARAM] button.
Change the value.
4
5
6
Touch and Hold
Touch