Operation Manual

ManualsBrandsHammond ManualsAudioXK 3-C

Setting the Parameters

SYSTEM

In this mode, you can set the SYSTEM PARAMETERS of this keyboard and the

display information.

To locate this mode:

Touch the [MENU/EXIT] button to display the MENU, select PAGE E by the [PAGE] button,

and then touch the [2] SYSTEM button.

1. NOISE GATE - RETURN

Switches the action of the Noise-Gate of the Effect Loop and the Return jack.

THRESHOLD 1THRESHOLD 1

THRESHOLD 1:

THRESHOLD 2THRESHOLD 2

THRESHOLD 2:

The audio output is switched ON/OFF according to the volume input to the

Return jack.

THRESHOLD 2 switches ON/OFF at lower volume than THRESHOLD 1.

OPENOPEN

OPEN:

The audio output is always ON.

2. KEY MODE - MANUAL

This is for using this keyboard with a MIDI keyboard as a LOWER keyboard or not.

SINGLESINGLE

SINGLE:

Select this when you use this keyboard as a single keyboard.

The parameter MIDI IN (P. 96 #2) sets “IN1/IN2”, LINK LOWER / PEDAL (P. 58

#3) “ON”.

DOUBLEDOUBLE

DOUBLE:

Select this when you use this keyboard with a MIDI keyboard as a LOWER

keyboard, such as XK-System.

The parameter MIDI IN (P. 96 #2) sets “LOWER/PEDAL”, LINK LOWER / PEDAL

(P. 58 #3) “OFF”.

NOTE: The parameter MIDI IN is synchronized with this parameter. The Parameter Link Lower

/ Pedal is set by this parameter, but you can set a different value after this procedure.

3. VERSION - MAIN PROGRAM

4. VERSION - TONE INFORMATION

5. VERSION - D.S.P. PROGRAM

6. VERSION - DEMONSTRATION DATA

7. VERSION - BOOT LOADER

These are the versions of each software built in this keyboard.

These are only for displaying the version number.

NOISE GATE

The Noise Gate is a device to eliminate noises while

you are not playing. If the input tone signal goes down

below a certain level (= “Threshold Level”), this auto-

matically “close”s the gate and becomes silent, to cut

the noise.

However, this sometimes could be a problem. This hap-

pens when a sound signal with a slow attack or release

is put in, for example, when such an Effector as Slow

Gear or Delay is connected to the Effect Loop of this

keyboard. The sound may suddenly come out or be

cut off.

In such a case, you must always “open” the gate to

pass all signals.

3 5