Operation Manual

ManualsBrandsHammond ManualsAudioXK 3-C

100

*#1 :-%Owner’s Manual

ZONES

INTERNAL ZONE

1. PEDAL

2. INTERNAL KEYBOARD - LOW

3. INTERNAL KEYBOARD - HIGH

This is for setting the playing range of each part of the built-in

sound engine by the internal keyboard.

Set the lowest note at LO and the upper most note at HI. The

upper most function of the manual bass is set at PED.

4. SPLIT POINT

If you use the Split function, set the KEY on where to split the

LOWER and the UPPER Parts on the keyboard.

The setting value is the highest note used in the LOWER Part.

NOTE: You can come to this mode by holding down the [SPLIT]

button as well.

NOTE: For 1 to 4, you can set the value by touching the [REC/JUMP]

button, while holding down a note on the keyboard.

5. LOWER OCTAVE

This is for setting the pitch of the split LOWER Part by the oc-

tave.

If you use the SPLIT function, the pitch of the LOWER Part may

go down too low for the harmony play. In that case, you can move

up the Lower octave up to the pitch suitable for harmony play.

6. LOWER KEYBOARD - LOW

7. LOWER KEYBOARD - HIGH

In case the MIDI IN (P.96 #2) is “LOWER/PEDAL”, this sets

the tonal range for playing the built-in sound engine (LOWER

PART and PEDAL PART by MANUAL BASS) by the Lower

Keyboard. Set the lower limit note by LO and the higher limit

note by HI.

8. LOWER KEYBOARD - OCTAVE

This shifts the note information by a octave for the built-in sound

engine played by the Lower keyboard.

In case the built-in sound engine does not pronounce as a result

of having set the playing range by the Lower Keyboard - Low/

High (#6, 7), adjust it using this parameter. The setting range is

from -2 to +2. The note does not sound, in case the shifted note

information is out of the pronouncing range of the built-in sound

engine.

To control the external MIDI equipment, a certain range of

the manual keyboard of this keyboard is used for that. Each

of them is called the “EXTERNAL ZONE”.

At the same time, you can set the oscillating range (= “IN-

TERNAL ZONE”) of the built-in sound engine and play it

on the same single keyboard.

Also, each MIDI keyboard connected to the MIDI IN

(LOWER and PEDAL) can control the MIDI equipment

by the EXTERNAL ZONE.

To locate this mode:

Touch the [MENU/EXIT] button to display the MENU, select

PAGE D by the [PAGE] button, and then touch [1] ZONES.

1 2 3 4 5

9 10 11 12 13 14 15 16 17 18 19

6 7 8