Operation Manual
*#1 :-%Owner’s Manual
94
18. NOTE - PAN
This is for setting the Pan (= Control Change #10) of this Zone.
19. NOTE - VELOCITY
This is for setting the Velocity Curve to send to this zone.
The setting range is OF, 1 - 4. The velocity of OF is fixed at 100.
At 1 - 4, the more the value increases, the intense velocity is sent
regardless how light the key is touched.
20. EXPRESSION - MINIMUM
21. EXPRESSION - MAXIMUM
This is for setting the range of the expression to “compress” to
send to this Zone.
If the expression pedal is connected to this keyboard, generally,
the electronic organ will sound, even when the expression pedal
is fully returned or at 0.
With the GM sound engine, the sound does not come out at the
same setting. This parameter is to balance it.
You can select 0 - 63 by MIN, and 64 - 127 by MAX.
22. EXPRESSION - CONTROL NUMBER
This is for setting the Control Number of the Expression Pedal.
There are various methods of the volume control, depending on
the connected equipment. you can here set the number to nicely
control the volume of the connected equipment by this param-
eter.
You can select 7:Vol or 11:EXP.
23. MESSAGE - PITCH BEND
24. MESSAGE - MODULATION
25. MESSAGE - DAMPER
This is for determining whether or not to send the control infor-
mation to this zone.
For example, by using two zones, suppose you have set to sound
the piano and sax by touching one key. The damper is effective
on the piano but strange on sax. On the other hand, Pitch Bend is
suitable for sax but not necessary for the piano. Now, you need to
limit the message to send to each zone.
ON sends the message, but OF does not.
You can also select which footswitch to use for sending the damper.
OFOF
OFOF
OF:
does not send the damper information.
1T1T
1T1T
1T
, 1R 2, 1R 2
, 1R 2, 1R 2
, 1R 2:
each sends the damper information by the tip of the
footswitch 1, ring, and EXP-100F.
NOTE: All the parameters in these modes are Preset Parameters.
They can be recorded to the Combination Preset. See the
Appendix for details of the Preset Parameters.
1 2 3 4 5
9 10 11 12 13 14 15 16 17 18 19
6 7 8