Operation Manual

*#1 :-5[UVGOOwner’s Manual

ADVANCED OPERATION FOR THE XPK-3

REBOUND TIME

MIDI CHANNEL

LOAD DEFAULT VALUES

If you play pedals with a staccato action or the leaf spring

used on the pedal keyboard may happen to change its char-

acteristic, it may cause “key bounce” on the key when you

release it.

You can avoid it by adjusting the “Rebound Time”.

To change the value, turn on the power while pressing the

highest B and the key corresponding to its value. (See the

left figure.)

Then, the LED on the left of the Expression Pedal blinks

slowly the number of times indicating the value.

The setting range is 1 to 16 times (x) 1.22 milliseconds. 4

times (x) 1.22 milliseconds is the default.

Note: Too long rebound time causes delay in the sound.

You can change the MIDI channel of the Pedal Keyboard for

special purposes.

To change the MIDI channel, turn on the power while press-

ing the highest C and the key corresponding to its value.

(See the left figure.)

Then, the LED on the left of the Expression Pedal blinks fast

the number of times indicating the value.

The setting range is Channel 1 to 16. Channel 3 is default.

To reset the XPK-3 to the initial status, turn on the power

while pressing the highest A#, B and C.

Then, the LED on the left side of the Expression Pedal blinks

three times, indicating the reset procedure.