Instructions / Assembly

5



Wrong

Right

 FasteningCabinetstotheWall

1. Screwwallcabinetsandtallcabinetstothepredeterminedheightthroughthebackpanelintoastud.

Makesuretoplacescrews1”belowthetopand1”abovethebottom.Measureandmarkthestud

locationonthecabinetbeforedrilling.Use#8x2‐1/2”flatheadscrewswhenfasteningthroughasingle

layerofdrywallintowoodstuds.

2. Placeascrewatthetopofthecabinetandthebottomofacabinetinasmanystudsascanbelocatedin

thecabinetwidth.







3. Levelthecabinets.



4. Important:Makesurethecabinetsaresquarebyplacingaframingsquareinsideoroutsideofthe

cabinet.Framelesscabinetscanberacked(orslightlytwisted)beforetheyarefastenedinplace.

W3036

Correcting for a “Bowed In” or “Bellied” Wall Condition

Boxes are at an angle

to each other

Box faces are

not aligned

W3036 W3036 W3036

Proper shimming will allow cabinet boxes to be aligned along a flat plane

and the door facia to be adjusted within acceptable tolerances

Placescrews1”

belowthe

insideto

of

Placescrews1”

abovetheinside

bottomofcabinet