Instructions / Assembly

STEP 4: Lift up light fixture to make wire connections.
Please refer to Figure 3 and 4.
Note: make sure the power is off.
1. Disassemble the upper cap, and install the canopy to
the fixture, install the nut, lock washer, ground wire to
the threaded pipe of light fixture. See figure 3. Tighten
until canopy is well secured.
2. Locate the s
upply ground wires from the outlet box and
the ground wire coming out of the light fixture. Connect
both ground wires with green ground screw and secure
on the circular strap.
3. Using approved wire connectors:
- Connect the light kit white wire to the white supply
wire
from outlet box; and
- Connect the light kit black wire to the black supply wire
from outlet box.
4. After connection the wires, spread them apart so that
green and white wires are on one side of the outlet box
and the black wires
are on the other side. Refer to figure
4.
STEP 5: Finish the installation.
1. Assemble the light fixture to the circular strap by placing
the holes in the canopy over the two mounting screws
protruding from the circular strap. See Figure 4.
2. Install the two decorative nuts over the two mounting
screws and tighten securely.
NOTE: It may be necessary to adjust the mounting
3. Install two 13 watts maximum compact fluorescent bulbs
(included) into the bulb socket.
CAUTION-RISK OF
FIRE, USE MAXIMUM
13 WATT COMPACT
FLUORESCENT BULBS.
4. Insert the pipe nipple and pull chain of light fixture
5. Place the lower cap (the one without grommet hole) over
the pipe nipple and up against the glass. Raise whole
glass shade assembly to the light fixture.
Your ceiling light fixture installation is completed!
Figure 3
Figure 4
Figure 5
Wire
connectors
Ground wire
Ground screw
Decorative nuts
Light fixture
mounting screws
Canopy
Light fixture
Pipe nipple
CFL Bulbs
Lower cap
Finial
Glass shade
2
Canopy
Hex Nut
Light fixture
Lock washer
Ground wire
Lock washer
screws length from the circular strap by turning the
screws out of the circular strap. If this is necessary,
reassemble the fixture by completing above sub-steps
1 and 2.
through the eyelet in the glass shade.
6. Place the finial over the threaded pipe nipple,in the mean
time, let the pull chain of light fixture go through
finial. Tighten the finial securely. Refer to Figure 5.