Installation Guide

Laminate Countertop How-To-Install Guide
AVOID
STEP 8:
BUILD-UP
A Build-up Kit (A KIT) is required
on some cabinetry to ensure that the
drawers have enough clearance to slide
open. (STEP 8)
STEP 9:
ASSEMBLING THE MITER
Miter sections should be joined together
before installing on the cabinet. A Miter
Bolt Kit (B KIT) is required to assemble
the miter. (STEP 9)
STEP 10:
END FINISHING
To finish the ends of the countertop, use
an End Cap Kit (C KIT) or End Splash Kit
(D KIT). (STEP 10)
STEPS 11 & 12:
MOUNTING ON CABINET
The countertop can be scribed to
match the wall surface. The backsplash
overhang is used for this purpose. Place
the countertop on the cabinet, use
a pencil to mark the top edge of the
countertop and file or sand to the line.
(STEP 11)
Put countertop in place, check the level
and stability. Secure to cabinets with
wood screws or panel adhesive. If using
screws, check length to assure that they
won’t protrude through the countertop.
Use caulking compound to seal top to
wall. Wipe off excess. (STEP 12)
FOLLOW INSTALLATION
INSTRUCTIONS ENCLOSED
WITH YOUR SINK OR SINK RIM
8
9
10
11
12
REMOVING OLD COUNTERTOP:
For safetydisconnect all utility service.
SHUT OFF WATER under sink or at water meter valve.
SHUT OFF ELECTRICITY at meter panel, if removing
garbage disposal or cook top unit.
DISCONNECT SINK DRAIN AT TRAP
DISCONNECT PLUMBING SUPPLY AT UNIONS
PROTECTING YOUR COUNTERTOP:
Do not place hot items directly on laminate surface:
– Use a trivet or other protective surface under pots/pans,
waffle irons, curling irons, clothing irons, etc.
Do not use knives or other sharp utensils that may slice or
scratch the laminate surface:
– Use a cutting board for chopping and slicing.
Do not slide abrasive items (such as ceramics) across the
laminate surface:
– Use a placemat or protective surface underneath these items.
CARING FOR YOUR COUNTERTOP:
For everyday cleaning, use a clean, damp non-abrasive cloth
with a mild detergent or household cleaner. For stuck-on
residue, scrub with a nylon bristled brush.
For difficult stains, apply a paste of baking soda and water to
draw out the stain. Blot away with a damp cloth (do not rub).
Never use cleaners containing acid, alkali or bleach.