Instructions / Assembly

8
5. To install light kit glass shade, remove
the
socket ring on the light
kit and install
the glass shade to the light kit. Secure by
tightening the socket ring previously
.
removed. (Figure 20)
6. Install three E27*13W bulbs. (included)
7. Restore power and your light kit is ready
for operations.
Installing the Light Kit
CAUTION To Reduce The Risk Of Electric
Shock, Disconnect The Electrical Supply
Circuit To The Fan Before Installing Light
Kit.
REMEMBER The fan blades must already
be attached to the fan.
Your fan and light kit though pre-wired have
been disassembled at the factory to ease in
shipping. Please follow these steps to
complete the installation of your fan and
light. TO REDUCE THE RISK OF FIRE
D O N O T E X C E E D M A X I M U M
WATTAGE RATING.
1.Remove 1 screw and loosen 2 screws on the
mounting plate. Secure the compartment box
cover to the mounting plate by tightening
screws previously removed and loosened.
(Figure 18)
2.Remove 3 screws on compartment box cover.
(Figure 19)
3. While holding the light kit assembly under
your fan, snap together the wire connection
plug. (Figure 19)
4. Carefully push all wires back into the
compartment box, then install the light kit
assembly onto the compartment box cover with
the 3 screws previously removed. Be sure to
tighten all screws. (Figure 19)
Figure 18
MAKE SURE TO LEAVE ENOUGH SPACE
BETWEEN THE FAN PULL CHAIN AND
THE BULBS TO THE CHAIN DOESN’T RUB
AGAINST ANY OF THE BULBS. LIGHT
BULBS HAVE NO WARRANTY, CAN BE
P U R C H A S E D A T L O C A L H O M E
IMPROVEMENT STORE OR FROM OUR
SERVICE CENTER.
NOTE:
Figure 20
Compartment box cover
Figure 19
Housing
Screw
Wire connection
plug
Compartment
box
Light kit
Compartment
box cover
Socket ring
Housing
C
F
L
screw
mounting plate