Instructions / Assembly

12
Assembly — Attaching the Fan Blades
Fastening the blade assemblies
to the fan motor assembly
7
Fastening the blade assemblies
to the fan
8
MOC.YABNOTPMAH
Please contact 1-800-HD-HAMPTON for further assistance.
G
A
H
H
A
H
A
WARNING: Failure to properly seat the blades (A) on the
blade arms (I) and engage in the locking mechanism(SS) could
result in the fan blades (A) loosening and possiblyfalling.
□
To install the blade to the blade arm:
Mount the fan blade (A) to the blade bracket (I) by aligning
the three key-slot holes in the blade (A) with the three posts on
the top of the blade bracket (I).
Firmly slide the blade (A) away from the blade arm (I)until the
blade (A) engages in the lockingmechanism (SS). Make sure the
locking mechanism (SS) at the rear of the blade bracket (I) springs
upward and butts against the edge of the blade (A), indicating a
secure connection.
Visually inspect the top of the blade bracket (I) to ensure the
locking mechanism（SS） is securely in place.
Repeat this procedure for the remaining blades (A).
To detach the blade from the blade arm:
Press down the locking mechanism (SS) to release the blade (A)
from the blade arm (I). Slide the blade (A) toward the blade arm (I)
until the blade (A) disengages from the locking mechanism (SS).
Carefully push the blade (A) up to detach from the blade arm (I).
□
□
□
Fasten the blade assemblies to the fan motor assembly (H) by
lining up the slots of the motor with the tabs on the blade
arms (I).
Tighten the two blade arm screws (BB) already installed in the
blade arms (I).
Repeat this procedure for the remaining blade arms(I)
□
□
□
□
SS
G
Loose the fiver screws and remove the five plastic blocks from
the fan motor assembly (G) before attaching the blade holder (I)
to the fan motor assembly (G). Discard the plastic blocks and
the five screws.
□