Instructions / Assembly

5 HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Installation

Preparing for installation

Attaching the canopy to the outlet

box

□ Fasten the mounting bracket (AA) onto the outlet box using

two outlet box screws (BB).

□ Screw the threaded tube (II) into the mounting bracket (AA),

and secure it using the lock washer (HH) and hex nut (FF).

NOTE: This threaded tube (II) should extend long

enough to protrude through the canopy when it is

mounted. (Adjust as needed)

□ Place the canopy (A) over the threaded tube (II), and screw the

screw collar loop (EE) onto the threaded tube (II).

□ Secure the canopy (A) using the ring (DD).

Attaching the chain

Weaving the fixture wire

□ Adjust the chain (B) to the desired height by spreading apart

the end link of the chain (B). Use a pair of pliers and a

screwdriver. Wrap a soft cloth around the pliers to protect the

chain’s finish.

□ Attach one end of the chain (B) to the screw collar loop (EE)

and the other end to the fixture body (C).

□ Unscrew the ring (DD) from the screw collar loop (EE), and

lower the canopy (A) and ring (DD) over the chain (B) on the

fixture.

□ Weave the fixture wires and bare copper ground wire up

through the chain (B), ring (DD), canopy (A), screw collar loop

(EE), threaded tube (II), and then into the outlet box.