Installation Guide

Attaching the Fan Blades
1. Attach the fan blades to the motor assembly
using the screws and fiber washer provided,
tighten screws securely.(Figure 17)
2. Align motor holes to blade and secure with
screws provided, tighten screws securely.
Repeat procedure with remaining blades.
(Figure 17)
Figure 18
Touching
ceiling
Figure 17
7
Blade balancing
The following procedure should correct
most fan wobble. Check after each step.
Blade
Screws
Fiber Washers
Blade Slot
Mounting
Ring
1.
Check
that all blades and blade holder
screws are secure.
2. Most fan wobble problems are caused
when blade levels are unequal. Check this
level by selecting a point on the ceiling
above the tip of one of the blades. Measure
this distance as shown in Figure 18. Rotate
the fan until the next blade is positioned for
measurement. Repeat for each blade. The
distance should be equal within 1/8". Run
the fan for 10 Minutes.
3. Use the enclosed Blade Balancing Kit if
the blade wobble is still noticeable.