Installation Guide

Installing the light kit
REMEMBER to disconnect the power.
The fan blades must already be attached to
the fan.
Your fan and light kit though pre-wired
have been disassembled at the factory to
ease in shipping. Please follow these steps
to complete the installation of your fan and
light. TO REDUCE THE RISK OF FIRE
DO NOT EXCEED MAXIMUM
WATTAGE RATING.
ATTENTION: The Energy Policy Act of
2005 requires this fan to be equipped with a
190 watt limiting device. If lamping exceeds
190 watts, the ceiling fan's light kit will shut
off automatically.
1. Remove 1 of 3 screws on the mounting
ring and loosen other 2 screws. (Do not
remove)
2. Remove the switch cover from the light
kit by removing four screws from the light
kit. Place the key holes on the switch cover
over the 2 screws previously loosened
from the mounting ring, turn switch cover
until it locks in place at the narrow section
of the key holes. Secure by tightening the 2
screws previously loosened and the one
previously removed. (Figure 19 )
LIGHT BULB HAVE NO WARRANTY, CAN BE
PURCHASED AT LOCAL LIGHT BULB
SPECIALTY STORE OR FROM OUR SERVICE
CENTER.
4. Connect the connectors from the light
kit and fan. (Figure 19 )
5. Lift the light kit to the mounting plate,
align the key holes and tighten 4 screws
previously removed.
6. Place the 3 bulbs (40 Watt, included)
into the Light kits.(Figure 20)
7.Remove the two washers, metal nut,
metal cap and final from the light kit.
8. Install the glass shade, along with 2
washers previously removed, twist with
the metal nut; install the metal cap, then
twist the finial securely. (Figure 20)
9. Restore power and your ceiling fan
is ready for operations.
8
NOTE:
Figure 19
Figure 20
Switch housing
Glass shade
Finial
Metal Cap
Metal Nut
Rubber Washer
Metal Washer
Screws
Screws
Connection Plugs
Light Kit
Switch cover
Mounting ring
Reverse switch