Installation Guide

Figure 6
Downrod
Supply
wires
Figure 8
Figure 5
Cross pin
Hanger
ball
Downrod
Figure 7
Outlet box
Hanger bracket
Hitch
pin
Lock
pin
Set
screws
4
Hanging the Fan
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
1. Secure the hanger bracket to the ceiling
outlet box with the screws and washers
provided with your outlet box. (Figure 5)
2. Loosen the two set screws and r emove the
hitch pin and lock pin from the motor
assembly. (Figure 6)
3. Remove hanger ball from downrod assembly
by loosening set screw, removing the cross pin,
and sliding ball off rod. (Figure 7)
4. Carefully feed fan wires up through the
downrod. (Figure 8) Thread the rod into
the coupling. Next, line up holes and
replace lock pin and hitch pin. Tighten set
screws.
5. Remove three set screws on the scroll
bracket. Install the scroll to the scroll
bracket by attaching screws previously
removed. Do not tighten. Repeat the
procedure for the other two scrolls.
(Figure 9A)
6. Slip coupling cover, scroll assembly
(Figure 9)
onto
downrod. Secure scroll assembly to the
motor housing by tightening three screws
provided in loose bag into the motor
housing. Tighten three screws removed in
step 5. Secure the scroll assembly to the
downrod by tightening the small set screw
on the scroll bracket. (Figure 10)
7.
8. Now lift motor assembly into position and
place hanger ball into hanger bracket. Rotate
until the check groove drops into the registration
slot and seats firmly. (Figure 12) Downrod
should not rotate if this is done correctly.
Slip canopy cover and canopy onto
downrod. (Figure 11) Carefully reinstall
hanger ball onto downrod. Make sure that
cross pin is in correct position, set screws
are tighten and wires are not twisted.
Small set Screw
Set Screw
Scroll
bracket
Motor
Housing
Lead Wires
Figure 10
Small set
Screw
Scroll
Screw
Motor Collar
Screw
Lead Wires
Hanger Ball
Canopy
cover
Canopy
Figure 11
Split Pin
Pivot Pin
Motor Collar
Figure 9
Set Screw
Figure 9A