Installation Guide

8
Remove the fan from the hook on the ceiling
mounting plate. Secure the upper housing to the
mounting plate with four screws provided. (Fig.
17)
Insert the blade through the blade slot in the
decorative housing. Align the holes in blade
and blade arm, place the blade support plate on
blade as showing in Figure 19, making sure the
holes are also aligned and secure with fiber
washers and screws provided.
Repeat process with other blades.
Finishing the Fan
Installation
Attaching the Fan Blades
Close-to-Ceiling Mounting
Downrod Mounting Installation
Figure 17
Screws
Ceiling
Mounting
Plate
Upper Motor
Housing
Blade Support Plates
Screws
Fiber Washers
Blades
Slots
WARNING
MAKE SURE THE TAB ON THE HANGING
BRACKET PROPERLY SITS IN THE GROOVE IN
THE HANGER BALL BEFORE ATTACHING THE
CANOPY TO THE BRACKET BY TURNING THE
HOUSING UNTIL IT DROPS INTO PLACE.
Tuck connections neatly into ceiling outlet box.
Slide the canopy up to hanger bracket and place
the key hole on the canopy over the screw on the
hanger bracket, turn canopy until it locks in place
at the narrow section of the key holes. (Fig. 18)
Align the circular hole on canopy with the
remaining hole on the hanger bracket, secure by
tightening the two set screws. Note: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
1.
2.
3.
Figure 18
Outlet Box
Hanger
Bracket
Screw
Screw
Canopy
Canopy
Bottom Cover
Figure 19
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NO INSERT FOREIGN
OBJECTS BETWEEN ROTATING FAN BLADES.
1.
2.