Installation Guide

4
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly.
NOTE: This ceiling fan is supplied with two types
of hanging assemblies; the "Downrod Mounting"
installation using the downrod with ball and socket
mounting, and the "Close-to-Ceiling" installation
using the ceiling mounting plate. The
"Close-to-Ceiling" mounting is recommended in
rooms with less than 8-foot ceilings or in areas
where additional space is desired from the floor to
the fan blades.
When using the "Downrod Mounting" installation,
the distance from the ceiling to the bottom of the
fan blades will be approximately 12 inches. The
"Close-to-Ceiling" installation reduces the
distance from the ceiling to the bottom of the fan
blades to approximately 9 inches.
Once you have decided which ceiling installation
you will use, proceed with the following
instructions. Where necessary, each section of the
instructions will note the different procedures to
follow for the two types of installation.
Note: Before starting installation, remove the
ceiling mounting plate from the motor by
removing the 4 screws from the upper motor
housing. (Fig. 5)
Note: Please proceed to "Making the Electrical
Connections" and continue on to "Finishing the
Fan Installation".
Hanging the Fan
Option 1:
Close to Ceiling Installation
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly.
Attach the ceiling mounting plate to the outlet
box with two screws and washers provided
with the outlet box. Make sure the mounting
plate is tight and secured (Fig. 6).
Lift fan into position by hanging the motor
assembly onto the hook from the ceiling
mounting plate allowing it to hang freely (Fig.
7).
1.
2.
Figure 7
Figure 5
Figure 6
Outlet Box
Ceiling Mounting
Plate
Upper Motor
Housing
Ceiling
Mounting
Plate
Screws