Installation Guide

6
WARNING
THE TAB IN THE RING MUST REST IN THE
GROOVE OF THE HANGER BALL AS FIGURE 15.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
Installing Fan to the
Electrical Box
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR OTHER PERSONAL INJURY.
MOUNT FAN ONLY TO AN OUTLET BOX OR
SUPPORTING SYSTEM MARKED ACCEPTABLE
FOR FAN SUPPORT AND USE THE MOUNTING
SCREWS PROVIDED WITH THE OUTLET BOX.
Pass the 120-volt supply wires through the
center hole in the hanger bracket as shown in
Figure 14.
Install the hanger bracket on the outlet box
with the screws and washers provided with
your outlet box. (Figure 14)
Securely tighten the two mounting screws.
Carefully lift the fan assembly up to the hanger
bracket and seat the hanger ball in the bracket
socket. Make sure the tab on the hanger bracket
socket is properly seated in the groove in the
hanger ball. (Figure 15) This will help to
balance the ceiling fan.
1.
2.
3.
4.
Figure 14
UL Listed Outlet Box
Hanger Bracket
120V
Wires
Mounting
Screws
(Supplied
with Electrical Box)
Tab
Figure 15
Groove
Tab
Figure 13
Pin in Locked
Positioon
Motor Wires
Downrod
Ceiling Canopy
Canopy Bottom
Cover
Motor Collar
Coupling Cover
Tighten Screw Firmly
Cotter Pin
Set Screw
Cross Pin
Clevis Pin
Hanger Ball
Figure 12
Downrod
Motor Wires