Installation Guide

Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1 Ground Screw (#9) 3 Wire Connectors (#6) 2 Outlet Box Screws (#5)
1 Circular Strap (#8) 2 Screw (#3)
INSTALLATION INSTRUCTIONS:
1. Attach the Circular Strap (#8) to the Outlet Box (#7) with the two Outlet box screws
(#5) as shown. The side of the Circular Strap marked “GND” must face out.
2. Connect the white wire from the fixture to the white wire from the Outlet Box (#7),
and the black wire from the fixture to the black wire from the Outlet Box (#7). Cover
the two wire connections using the two provided Wire Connectors (#6). Wrap the
two wire connections with electrical tape for a more secure connection. If your outlet
box has a ground wire (green or bare copper), connect fixture’s ground wire to it
using the wire connector (#6). Otherwise connect the copper ground from the fixture
to Ground screw (#9) on the Circular Strap (#8). Note: If you have electrical
questions, consult your local electrical code for approved grounding method.
3. Place Fixture Body (#4) over Circular Strap (#8) and secure with Screws (#3).
4. Install the proper light bulbs (not included) for your fixture. (DO NOT EXCEED
THE SPECIFIED WATTAGE!)
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn
the light switch on to activate the fixture.