Installation Guide

Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1 Ground Screw (#6) 3 Wire Connectors (#9) 2 Outlet Box Screws (#5)
1 Mounting Plate (#7) 4 Screw (#8) 2 Plastic Anchor (#11) 2 Wood Screw (#12)
INSTALLATION INSTRUCTIONS:
1. Position Mounting Plate (#7) on the wall, and mark location of two mounting holes.
Drill the holes on the wall, insert the Plastic Anchor (#11) into the wall.
2. Attach the Mounting Plate (#7) to the Outlet box (#10) using the Outlet Box Screws
(#5) and the Wood Screws (#12). The side of the mounting plate marked “GND”
must face out.
3. Connect the white wire from the fixture to the white wire from the Outlet Box (#10),
and the black wire from the fixture to the black wire from the Outlet Box (#10).
Cover the two wire connections using the two provided Wire Connectors (#9). Wrap
the two wire connections with electrical tape for a more secure connection. If your
outlet box has a ground wire (green or bare copper), connect fixture’s ground wire to
it using the wire connector (#9). Otherwise connect the copper ground from the
fixture to Ground screw (#6) on the Mounting Plate (#7). Note: If you have electrical
questions, consult your local electrical code for approved grounding method.
4. Place Fixture Body (#4) over Mounting Plate (#7) and secure with Screws (#8).
5. Install the proper light bulbs (not included) for your fixture. (DO NOT EXCEED
THE SPECIFIED WATTAGE!)
6. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn
the light switch on to activate the fixture.