Instructions / Assembly

Installation

Preparing for the mounting

bracket

Installing the mounting bracket

□ Tighten the support screws (AA) into the inside mounting

hole of the mounting bracket (A) (to be fully tightened

later), and secure with G5/32 in. hex nuts (DD).

NOTE: The support screws (AA) should extend long enough

to protrude through the canopy assembly (B) when it is

mounted. (Adjust as needed)

□ Fasten the mounting bracket (A) onto the outlet box using

two outlet box screws (CC).

Connecting the wires

□ Adjust five arms to mark an equal distance between arms.

□ Strip 3/4 in. of insulation from wire ends.

□ Connect the black wire from the canopy assembly (B) to the

black wire from the outlet box and the white wire from the

canopy assembly (B) to the white wire from the outlet box.

Twist the stripped ends together with pliers.

□ Loop the bare copper grounding wire from the canopy

assembly (B) under the head of the green ground screw

(BB) on the mounting bracket (A), and connect it to the

grounding conductor from the supply circuit.

□ Cover the wire connections with the wire connectors (EE).

Tape the wire connectors (EE) and wires together. Carefully

position all wires inside the outlet box.