Installation Guide

TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION
(not included):
ADDITIONAL PARTS FOR ASSEMBLY (included):
Page 3
Safety Goggles Wire Stripper Flathead
Screwdriver
Wire Cutters
Phillips
Screwdriver
Electrical Tape A19 Bulb 60W
Max. (not included)
Strand (A) Strand (B)
INSTALLATION INSTRUCTIONS:
1. Turn off power at main fuse box.
2. While depressing cable restraint (8) on pendant canopy (6), push or pull on cable
depending if you want to raise or lower your height. Do this adjustment prior to
installation.
3. Re-attach the cable stopper (which is located at the end of the suspension cable) at
the new height. This is an added safety precaution.
4. Push excess clear cord up into canopy (6), leaving a little slack to form an “S”
pattern by unfastening the wire restraint (9) mounted on canopy (6), and then
refasten wire restraint (9) once proper wire length is achieved.
5. Install mounting backplate (2) to junction box (1) with 2 screws supplied.
6. Fasten open end of ground wire (bare copper or green wire) to ground wire or
ground screw of junction box (1) or ground screw (5) on mounting backplate (3).
7. Connect black wire of power supply to the wire of the chandelier marked in
Black (coded at the tip) and connect white wire of power supply to the wire of the
chandelier left in clear or marked in White (coded at the tip).
NOTE: All wire connections should be made with wire nuts or marettes (included) and
pushed back into junction box (1). See Figure 1.
8. Mount canopy of pendant (6) over mounting backplate (2) and secure with side
screws (7) supplied.
Page 6
ADDITIONAL PARTS FOR INSTALLATION (included):
4. Mounting Screw
(x2)
3. Wire Nut (x3) 5. Ground Screw2. Mounting Plate
7. Side Screws (x2)6. Canopy