Instructions / Assembly

Pre-Installation
IMPORTANT: Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have occurred
during shipping. If there is a defect in the wire, do not
attempt installation. Please call Customer Service Team
at 1-800-388-6141 ext 216.
NOTE: This product requires one 60W maximum medium
base (E26) type A bulb or 9W maximum medium base (E26)
self-ballasted LED bulb (sold separately).
PLANNING INSTALLATION
Read all instructions before installing.
To avoid damaging this product, place it on a soft, non-abrasive surface, such as carpet or cardboard.
Phillips
Screwdriver
Safety
Goggles
Wire
Stripper
Electrical
Tape
Pliers
TOOLS REQUIRED (NOT INCLUDED)
HARDWARE INCLUDED
AA
BB
FFEE
CC
GG
DD
3
Part Description
Quantity
AA Mounting bracket
1
BB
Support screw (long)
(Pre-assembled to mounting bracket (AA))
2
CC Outlet box screw (short)
2
DD
Hex nut
(Pre-assembled to support screw (BB))
2
Part Description
Quantity
EE
Green ground screw
(Pre-assembled to mounting bracket (AA))
1
FF Wire connector
3
GG
Cap nut
(Pre-assembled to support screw (BB)
2