Installation Guide

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Standard Ceiling Mount

Routing the wires

Assembling the fan

Preparing for standard mounting

□ Loosen, but do not remove, the setscrews (II) on the collar

on top of the fan-motor assembly (D).

□ Align the holes at the bottom of the ball/downrod assembly

(B) with the holes in the collar on top of the fan-motor

assembly (D).

□ Carefully insert the hanger pin (BB) through the holes in

the collar and ball/downrod assembly (B). Be careful not to

jam the hanger pin (BB) against the wiring inside the ball/

downrod assembly (B).

□ Insert the locking pin (CC) through the hole near the end of

the hanger pin (BB) until it snaps into its locked position.

□ Re-tighten the setscrews (II) on the collar on top of the fan-

motor assembly (D).

□ Remove the canopy bottom cover (HH) from the canopy

unlocks.

□ Loosen the two canopy screws (GG) located in the bottom

of the mounting bracket, and turn the canopy counter-

clockwise to remove the mounting bracket (A) from the

canopy (C).

□ Route the wires exiting the top of the fan motor

assembly (D) through the center of the canopy bottom

cover (HH).

□ Make sure the opening of the canopy (C) is on top and

insert the ball/downrod (B) through the canopy (C).

□ Route the wires exiting the top of the fan motor

assembly (D) through the downrod as shown.

WARNING: Failure to properly install the locking

pin (CC) could result in the fan becoming loose and

possibly falling.