Full Product Manual

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Attaching the Light Kit

Attaching the light kit

Installing the bulbs and attaching the

glass bowl

□ Remove the three screws (QQ) from the light kit tter

assembly (E) below the fan motor assembly (D).

□ Connect the wires exiting the bottom of the motor assembly

(D) by connecting the molded adaptor plugs (SS) together

(black to black, white to white).

□ Slide the switch cup light kit (E) and secure it to the switch

housing using the three screws (QQ) that were removed in

the rst step.

□ Remove the nial from the switch cup/light kit assembly.

□ With power off, install the two bulbs (I) by twisting them

into the light bulb sockets. Position the glass bowl (H) over

the threaded nipple and pass the pull chain for the fan

through the hole under the glass bowl (H).

□ Re-install the nial.

□ Attach the pull chain extension (FF).

CAUTION: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light kit.

CAUTION: Make sure the power is off before attaching or

removing the glass bowl.

WARNING: Allow the glass bowl to cool completely before

removing.

CAUTION: Over lamping the fan will result in the fan lights

shutting down until the proper wattage bulbs are installed. Reset

the lights by turning off the power, replacing the bulbs with the

correct wattage bulbs, and turn the power on.