Full Product Manual

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Standard Ceiling Mount

Routing the wires

Assembling the fan

Preparing for mounting

□ Loosen, but do not remove, the 2 setscrews (PP) on the col-

lar on top of the motor housing (D).

□ Align the holes at the bottom of the downrod (B) with the

holes in the collar on top of the motor housing (D).

□ Carefully insert the hanger pin (CC) through the holes in the

collar and downrod (B). Be careful not to jam the hanger pin

(CC) against the wiring inside the downrod (B).

□ Insert the locking pin (DD) through the hole near the end of

the hanger pin (CC) until it snaps into its locked position.

□ Re-tighten the 2 setscrews (PP) on the collar on top of the

motor housing (D).

□ Remove the mounting plate (A) from the canopy (C) by

loosening the four screws on the top of the canopy (C).

□ Remove the two non-slotted screws (WW), and loosen the

slotted screws. This will enable you to remove the mounting

bracket (A).

□ Route the wires exiting the top of the fan motor (D)

through the canopy (C) and then through the ball/

downrod assembly (B).

□ Make sure the slot openings are on top and route the

wires through the canopy (C) and then through the

ball/downrod assembly (B).

WARNING: Failure to properly install the locking pin could

result in the fan becoming loose and possibly falling.