Use and Care Manual

Assembly - Close-To-Ceiling Mount

Preparing for close-to-ceiling

mounting

Routing the wires

1 2

□ Remove the canopy ring (KK) from the canopy (C) by

turning the ring counter clockwise until it unlocks.

□ Remove the mounting bracket (A) from the canopy (C)

by loosening the two canopy screws (II) located in the “L

shaped slots”.

□ Remove and save the two canopy screws (JJ) in the

round holes. This will enable you to remove the mounting

bracket (A).

□ Remove the decorative canopy bottom cover (LL) from the

canopy (C) by depressing the three studs.

□ Remove three of the six screws and lockwashers (MM) (every

other one) securing the motor collar (M) to the top of the fan

motor housing (E).

□ Route the wires exiting the top of the fan motor assembly (E)

through the rubber gasket (GG), canopy ring (KK) and ceiling

canopy (C) (make sure the slot openings are on top); place

the rubber gasket (GG) over the remaining three screws, then

proceed to place the ceiling canopy (C) over the motor collar (M).

□ Align the mounting holes with the holes in the motor (E) and

fasten, using the three screws and lockwashers (MM) removed

previously. Tighten the mounting screws securely.