Use and Care Manual

Assembly - Attaching the Fan Blades

Attaching the fan blades

Fastening the blade assemblies to

the motor

□ Attach blade (G) to blade bracket (H) using the screws (AA)

provided. Please note that the rubber washers are pre-

attached to the blade bracket (H). Insert a screw into the

blade bracket (H). Repeat for the two remaining screws (AA).

□ Tighten each screw securely.

□ Repeat these steps for the remaining blades.

□ Fasten the blade assembly to the motor (E) by inserting the

alignment post into the slot on the bottom of the motor (E)

and tightening the blade bracket screws (TT). Please note

that the blade bracket screws (TT) are pre-attached into the

blade bracket (H).

□ Repeat this step for the remaining blade assemblies.

Assembly - Installing the Fan without the Light Kit

Attaching the switch cup

□ Remove the three mounting screws (RR) on the black bracket

below fan motor assembly (E).

□ Connect the wire from the witch cup (F) to the wires exiting

the fan motor assembly (E) by connecting the molded

adaptor plugs together. Carefully tuck all wires and splices

into the switch cup (F).

□ Mount the switch cup (F) to the black bracket below the fan

motor assembly (E) by aligning the three screw holes and

securing with three screws (RR) that were removed in step 1.