Installation Guide

Operating Your Fan

Turn on the power and check the operation of the fan.

The pull chain controls the fan speeds as follows:

1 pull - High

2 pulls - Medium

3 pulls - Low

4 pulls - off

The appropriate speed settings for warm or cool weather depends on

factors such as the room size, ceiling height, and number of fans.

The fan is shipped from the factory with the reversing switch

positioned to circulate air downward. If airow is desired in the

opposite direction, turn your fan off and wait for the blades to stop

turning, then slide the reversing switch (XX) (located in switch cup) to

the opposite position, and turn the fan on again. The fan blades will

turn in the opposite direction and reverse airow.

Warm weather - Warm weather - (Forward) A downward airow creates

a cooling effect. This allows you to set your air conditioner on a warmer

setting without affecting your comfort.

Cool weather - (Reverse) An upward airow moves warm air off of the

ceiling. This allows you to set your heating unit on a lower setting

without affecting your comfort.

A. Warm weather

B. Cool weather

Installing the shatter resistant bowl

□ Position the shatter resistant bowl shade (G) over the

threaded nipple and pass the pull chain for the fan through

the pull chain guide (VV) on the side of the light kit (F) to

avoid the chain from touching the shatter resistant bowl

shade (G).

□ Install shade holder (LL), and nial (KK) to the threaded

nipple to secure the shatter resistant bowl shade (G)

properly.

□ Attach the pull chain extensions (AA).

CAUTION: Make sure the power is off before attaching or

removing the shatter resistant bowl.

WARNING: Allow the shatter resistant bowl to cool completely

before removing.

Assembly - Attaching the Light Kit (continued)

NOTE: Wait for the fan to stop before reversing the direction of

the blade rotation.