Installation Guide

11
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly - Hanging the Fan (continued)
Mounting the fan-motor assembly
(close-to-ceiling mount)
□ Carefully unhook the fan from the mounting bracket (A) and
align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock in place. Immediately tighten
the two mounting screws rmly.
□ Install the two mounting screws (HH) and lock washers (GG)
(saved from Assembly Step 1 “Prepairing for mounting” into
the holes in the canopy (C) and tighten rmly.
□ You may now proceed to attaching the fan blades.
WARNING: The locking slots of ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and rmly tightened.
6
A
C
E
GG
HH
Assembly - Attaching the Fan Blades
Attaching the fan blades
1
□ Mount the fan blades (H) to the blade bracket (I) by aligning
the three key-slot holes in the blade (H).
□ Insert and tighten the three blade screws (FF) in the blade
bracket holes.
□ Repeat for the remaining blades (H).
NOTE: Your fan blades are reversible. Select the blade
side nish which best accentuates you decor.
FF
H
I
Attaching the blade brackets
2
□ Fasten the blade bracket (I) to the motor (E) by
inserting the alignment post into the slot on the
bottom of the fan-motor assembly (E) and tightening
the motor screws.
□ Repeat for the remaining four blade brackets (I).
NOTE: Your fan blades are reversible. Select the blade
side nish which best accentuates you decor.
H
E
I