Installation Guide

Assembly - Hanging the Fan

Attaching the fan to the electrical

box

□ Pass the 120-Volt supply wires through the center hole in the

slide-on mounting bracket (A).

□ Install the slide-on mounting bracket (A) on the outlet box by

sliding the slide-on mounting bracket (A) over the two screws (JJ)

provided with the outlet box. If necessary, use leveling washers

(not included) between the slide-on mounting bracket (A) and

the outlet box. The at side of the slide-on mounting bracket (A)

should face toward the outlet box, as shown.

□ Securely tighten the two mounting screws (JJ).

WARNING: To reduce the risk of re, electric shock or

personal injury, mount to an outlet box marked “Acceptable

for fan support of 35 lbs. (15.9 kg) or less,” and use the

screws provided with the outlet box.

Hanging the fan

□ Carefully lift the fan-motor assembly (D) up to the slide-on

mounting bracket (A).

□ Insert the ball portion of the ball/downrod assembly into the

socket of the slide-on mounting bracket (A).

□ Turn the ball/downrod assembly clockwise until it is seated

with the tab of the slide-on mounting bracket (A) aligned with

the slot in the ball.

NOTE: The mounting bracket (A) is designed to slide into

place on an outlet box with the outlet box screws (JJ).