Installation Guide

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Hanging the Fan (continued)

Hanging the fan

□ Carefully lift the fan-motor assembly (F) up to the slide-on

mounting bracket (A).

□ If using the downrod, insert the ball portion of the ball/

downrod assembly (B) into the socket of the slide-on

mounting bracket (A).

□ Turn the ball/downrod assembly (B) clockwise until it is

seated with the tab of the slide-on mounting bracket (A)

aligned with the slot in the ball.

□ If using close-to-ceiling mounting, hang the fan on the hook

provided by utilizing one of the holes at the outer rim of the

ceiling canopy (C).

WARNING: The hook (UU) is only to balance the fan while

making the electrical connections. Failure to hang as shown

may result in the hook (UU) breaking, causing the fan to fall.

The hook must pass from the inside to the outside of the

canopy.

WARNING: When hanging the fan on the hook (UU) it is

critical that you use one of the non-slotted (round) holes in

the canopy (C).

Wiring the fan

□ Please refer to remote installation

instructions at the beginning of this

document.

IMPORTANT: Use the wire connecting nuts (CC) supplied with your

fan. Secure the connectors with electrical tape and ensure there

are no loose strands or connections.

NOTE: The fan comes with 54 in. lead wires for use with an

extended ball/downrod assembly. If using the ball/downrod

assembly (B) provided, you can cut the lead wires to your desired

length (no shorter than 12 in.).

WARNING: Remove the rubber motor stops on the bottom of the

fan before installing the blades or testing the motor.