Installation Guide

ManualsBrandsHampton Bay ManualsCeiling FansAntigua Plus 56 in. LED Brushed Nickel Ceiling Fan with Light Kit and Remote Control

Table Of Contents

WINK REMOTE INSTRUCTION 05102018 ENG.pdf
56in Antigua Plus 01082018.pdf
68108 Thermostatic Remote 01112017.pdf
- 68108 Thermostatic Remote 01112017.pdf
- 68108 Thermostatic Remote SPANISH 01112017.pdf
68108 Thermostatic Remote 01112017.pdf
- 68108 Thermostatic Remote 01112017.pdf
- 68108 Thermostatic Remote SPANISH 01112017.pdf

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Installing the Fan with the Light Kit

Attaching the light kit tter

assembly

□ Remove the three mounting screws (SS) on the black bracket

below fan motor assembly (E).

□ Attach the light kit tter assembly (J) to the switch cup (F) by

rst removing the decorative plug (ZZ) on the bottom of the

switch cup (F). Insert the wires from the light kit tter assembly

(J) through the hole in the bottom of the switch cup (F). Thread

the light kit tter assembly (J) into the hole on the bottom of

the switch cup (F). Secure with the hex nut (TT) provided.

□ Connect the blue wire exiting the bottom of the switch cup (F)

with the black wire from the top of the light kit tter assembly

(J). Connect the white wire exiting the bottom of the switch

cup (F) with the white wire from the top of the light kit tter

assembly (J).

□ Connect the wire from the switch cup (F) to the wires exiting

the fan motor assembly (E) by connecting the molded adaptor

plugs together. Carefully tuck all wires and splices into the

switch cup (F).

□ Mount the switch cup (F) to the black bracket below the fan

motor assembly (E) by aligning the three screw holes and

securing with three screws (SS) that were removed in step 1.

WARNING: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light xture.

Installing the glass shades

and bulbs

□ Remove the nial (WW), bottom cover (QQ), hex nut (PP) and

rubber washer (OO) from the light kit tter assembly (J).

□ With power off, install the two LED bulbs (L)(Max. 9.5W) by

screwing into the light bulb sockets.

□ Position the glass bowl (K) over the threaded nipple and

pass the fan switch chain through the chain guide on the

side of the light kit tter assembly (J).

□ Position the decorative cap (I) over the threaded nipple and

re-install the rubber washer (OO) and hex nut (PP) to the

threaded nipple to secure the glass bowl (K) properly. Do

not over tighten the hex nut (PP), over tightening the hex nut

(PP) may cause the glass to break.

□ Re-install the bottom cover and nial and nger tighten the

nial (WW).

□ Attach the chain switch (EE) to the fan and light chains.

NOTE: Notice the location of the fan’s reverse switch. This is

the switch used to change the fan’s directional rotation. For

more information on the operation of this switch, see Operating

Your Fan on page 14.