Warranty

HAMPTONBAY.COM
Please contact 855-HD-HAMPTON for further assistance.
Installation (continued)
4
Installing the fixture
□ Place the fixture body (C) to the wall and align the protruding mounting
screws (FF) through the appropriate holes on the wall plate portion of the
fixture body. Secure the fixture to the wall by threading the lock nuts (AA)
over the mounting screws (FF). Tighten securely.
□ Caulk the space between the wall and the upper 3/4 area of the wall plate
to prevent water seeping into the outlet box. Leave the bottom 1/4 area
uncaulked for drainage of any water which might leak into the enclosure.
□ Turn on the power at the circuit breaker or fuse box. Turn the light switch
to turn on the fixture.
Safety Information
Keep your receipt and these instructions for proof of purchase.
WARNING: Consult a qualified electrician for any electrical
questions.
CAUTION: Before starting installation of this fixture or removal of a
previous fixture, disconnect the power by turning off the circuit
breaker or by removing the fuse at the fuse box.
Troubleshooting
Problem
Possible Cause
Solution
The light bulb will not illuminate.
The light bulb is burned out.
Replace the light bulb.
The power is off.
Ensure the power supply is on.
There is a faulty wire connection.
Check the wiring.
There is a faulty switch.
Test or replace the switch.
The fuse blows or circuit breaker trips when the
light bulb is illuminated.
Wires are crossed or the power wire is not
grounded.
Check the wire connections.
Care and Cleaning
□ To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the glass and surface of the fixture.
□ To clean the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box. Next, use a dry or
slightly dampened clean cloth (use clean water, never a solvent) to wipe the inside glass and interior surface of the fixture.
□ Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry soft cloth to dust or wipe carefully.
Warranty
WHAT IS COVERED
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of three (3) years from date of purchase. This
warranty applies only to the original consumer purchaser and only to products used in normal use and service. If this product is found to be defective, the
manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion, provided that the product has
not been damaged through misuse, abuse, accident, modifications, alterations, neglect, or mishandling. This warranty shall not apply to any product that is found to
have been improperly installed, setup, or used in any way not in accordance with the instructions supplied with the product. This warranty shall not apply to a failure
of the product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation or any other failure not relating to faulty material or workmanship.
This warranty shall not apply to the finish or any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The
manufacturer does not warrant and specially disclaims any warranty, whether express or implied, or fitness for a particular purpose, other than the warranty
contained herein. The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including, but not
limited to, any labor/expense costs involved in the replacement or repair of said product.
Contact the Customer Service Team at 855-HD-HAMPTONor visit www.Hamptonbay.com.