Installation Guide

10. Chain Loop
Page 3
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION
(not included):
Safety Goggles Wire Stripper Flathead
Screwdriver
Wire Cutters
LadderPhillips
Screwdriver
Electrical Tape A19 Bulb 60W
max. (not included)
Page 6
ADDITIONAL PARTS FOR ASSEMBLY (included):
Strand (A) Strand (B)
INSTALLATION INSTRUCTIONS:
1. Turn off power at main fuse box.
2. Tighten chain loop (10) onto xture main body.
3. Install mounting plate (2) assembly complete with nipple (7) and canopy loop (8) to
junction box (1) with 2 mounting screws (4) as one complete assembly.
4. Remove loop ring (9) from canopy loop (8). Slip canopy (6) over canopy loop (8) and
secure by fastening loop ring (9). Adjust the height of the nipple (7) so canopy (6) will
sit at against ceiling and tighten lock nut (13) against mounting plate (2).
5. Remove loop ring (9) and canopy (6) from ceiling. Hold pendant up against canopy loop
(8) with chain and adjust to desired height. Remove excess chain.
6. Before fastening chain onto canopy loop (8) weave pendant wire through every second link.
Let the canopy loop ring (9) slip to the bottom of chain. Repeat this step for canopy (6).
7. Secure chain onto canopy loop (8). Weave wire through the canopy loop (8) and into
junction box (1).
8. Install both ground wires of pendant (one from the canopy (6) and one from the lead wire
of the pendant) to ground screw (5) or ground wire of junction box (1) or ground screw
(5) on the mounting plate (2). (Ref. to Figure 1)
9. Connect black or other wire of power supply to the smooth side of the wire (exible
cord) from the pendant and connect white wire of power supply to the knobbed side of
the wire from the pendant. (Ref. to Figure 1)
Note: always use wire nuts (3) marrettes (included) to connect wires and push all excess
wire and connections back into junction box (1).
10. Lift canopy (6) up to ceiling covering junction box (1) and secure by using canopy
loop ring (9).
ADDITIONAL PARTS FOR INSTALLATION (included):
4. Mounting
Screw (x2)
3. Wire Nut (x3) 5. Ground
Screw
2. Mounting
Plate
13. Lock Nut9. Loop Ring7. Nipple 8. Canopy
Loop
6. Canopy