Installation Guide

PARTS INCLUDED FOR INSTALLATION
(parts are not to scale):
INSTALLATION INSTRUCTIONS:
1. Turn off power at main fuse box.
2. Mount mounting plate to junction box (1) with outlet box screws (10). Make sure
black and white wires of junction box (1) run through the middle opening of the
mounting plate.
3. Fasten open end of ground wire (bare copper or green wire), to ground wire or
ground screw (9) of junction box (1) or ground screw (9) on cross bar (3). (Refer
to Figure #1).
4. Connect black wire of power supply to black wire of the xture and connect
the white wire of the power supply to the white wire of the xture. (Refer to
Figure #1).
NOTE: Always use wire connectors (2) or marettes (included) to connect wires and
push all excess wire and connections back into junction box (1).
5. Mount canopy (6) over cross bar (3) and tighten with 2 nishing nuts (11).
Page 6 Page 7
2. Wire Nut 3. Mounting Plate
9. Ground Screw
6. Canopy
10. Outlet Box
Screws
11. Finishing Nut
(x2)
8. Mounting Screw
Figure #1
GROUND WIRE
FROM HOUSE FROM FIXTURE
GROUND WIRE
BLACK (OR RED) WIRE
FROM HOUSE FROM FIXTURE
BLACK OR SMOOTH
WHITE OR RIBBED
FROM HOUSE FROM FIXTURE
WHITE OR RIBBED
INSTALLATION:
Black Wire
White Wire
Ground Wire
3. Mounting Plate
8. Mounting Screw
9. Ground Screw
10. Outlet Box
Screws
6. Canopy
11. Finishing Nut (x2)
1. Junction Box
(not included)
2. Wire Nuts
4. Lock Nut
4. Lock Nut