Use and Care Manual
Table Of Contents
12
Attaching the fan blades
2
□ Mount the fan blades (J) to the blade bracket (I) by aligning
the three key-slot holes in the blade (J) with the three posts
on the top of the blade brackets (I).
□ Hold the blade (J) close to the blade bracket (I) and press
the blade (J) down rmly. Ensure the key-slot holes are
properly seated on the blade arm posts.
□ While still holding the blade (J) down, rmly slide the blade
(J) away from the bracket (I) side until the blade (J) engages
in the locking mechanism (SS).
□ Make sure the locking mechanism (SS) at the rear of the
blade bracket (I) springs upward and butts against the edge
of the blade (J) indicating a secure connection.
□ Visually inspect the top of the blade bracket (I) to ensure the
locking mechanism (SS) is securely in place.
□ Repeat for the remaining blades (J).
NOTE: Your fan features revolutionary advancements
for quick and easy blade installation.
Assembly - Attaching the Fan Blades
Assembly - Attaching the Light Kit
Attaching the light kit
1
□ Remove the three screws (QQ) from the light kit tter
assembly (G).
□ Connect the wires exiting the bottom of the motor assembly
(F) by connecting the molded adaptor plugs together (blue to
blue, white to white).
□ Slide the light kit (G) and secure it to the switch housing
using the three screws (QQ) that were removed in the rst
step.
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light kit.
I
J
SS
F
QQ
G