Use and Care Manual
Table Of Contents
7
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparing for mounting
□ Remove the canopy ring (D) from the canopy (C) by
turning the ring counter-clockwise until it unlocks.
□ Remove the mounting bracket (A) from the canopy (C)
by loosening the two canopy screws (FF) located in the
“L shaped” slots.
□ Remove and save the two canopy screws (FF) and lock
washers (GG) in the round holes. This will enable you to
remove the mounting bracket (A).
□ Route the wires exiting the top of the fan motor (F),
through the coupler cover (E), and canopy ring (D).
□ Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the
ball/downrod assembly (B).
2
3
1
□ Remove the setscrew (RR) by turning it counterclockwise.
□ Install the downrod (B) by inserting it into the motor collar
(TT), and turning it clockwise until it is tight.
□ Reinstall the setscrew (RR) turning clockwise until tight.
CAUTION: To ensure wobble-free operation and to
avoid damage to the fan, the downrod (B) and the
setscrew (RR) must be completely tightened
A
GG
FF
C
D
C
D
E
B
F
B
RR
TT
C
D
E
F