Instructions / Assembly

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Attaching the Switch Cup

Attaching the switch cup

□ Remove the three screw (VV) from the switch cup cover (F)

and save them.

□ Align the three holes in the switch cup below the fan motor

assembly (E) with the three holes in the switch cup cover (F).

Make sure the notch in the switch cup cover (F) clears the

reversing switch in the switch cup.

□ Position the switch cup cover (F) and re-install the three

screws that were removed in rst step to secure the switch

cup cover (F).

□ Attach the pull chain extensions (EE) to the fan pull chain.

CAUTION: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light xture.

NOTE: Notice the location of the fan’s slide switch. This is

the switch used to change the fan’s directional rotation.

For more information on the operation of this switch, see

Operating Your Fan on page 13.

Turn on the power and check the operation of the fan. The fan pull

chain controls the fan speed as follows:

1 pull - High, 2 pulls - Medium, 3 pulls - Low, 4 pulls - off

The appropriate speed settings for warm or cool weather depends on

factors such as the room size, ceiling height, and number of fans.

The slide switch (XX) controls the direction of the blades: forward

(switch left) or reverse (switch right).

A. Warm weather - (Forward) A downward airow creates a cooling

effect. This allows you to set your air conditioner on a higher setting

without affecting your comfort.

B. Cool weather - (Reverse) An upward airow moves warm air off of the

ceiling. This allows you to set your heating unit on a lower setting

without affecting your comfort.

NOTE: Wait for the fan to stop before reversing the direction of the

blade rotation.

Operation

OPERATING YOUR FAN

A. Warm Weather

B. Cool Weather