Instructions / Assembly

Installing the bulbs and shatter

resistant bowl

□ Remove the nial and the bottom cover from the threaded

nipple of the light kit tter assembly (E).

□ With the power off, install the two LED bulbs (I) by screwing

them into the light bulb sockets.

□ Position the shatter resistant bowl (H), re-install the bottom

cover over the threaded nipple, and direct the fan pull chain

through the side hole of the bottom cover.

□ Re-install the nial over the threaded nipple and direct the

light pull chain through the hole of the nial, and tighten the

nial securely.

□ Attach the pull chain extensions (EE) provided to the light pull

chain and fan pull chain.

CAUTION: Make sure the power is off before attaching or

removing the shatter resistant bowl.

WARNING: Allow the shatter resistant bowl to cool completely

before removing.

CAUTION: Do not over tighten the hex nut. Overtightening the

hex nut may cause the shatter resistant bowl to break.

Assembly - Attaching the Lights

Attaching the light kit tter assembly

□ Remove the three screws (VV) on the switch cup cover of the

light kit tter assembly (E).

□ Connect the wires from the light kit tter assembly (E) to the

wires from the switch cup of the fan-motor assembly (D) by

connecting the molded adaptor plugs together (blue to black,

white to white). Carefully tuck all wires and splices into the

switch cup.

□ Align the three holes in the switch cup cover of the light kit

tter assembly (E) with the three holes in the switch cup

of the fan-motor assembly (D). Make sure the notch in the

switch cup cover of the light kit tter assembly (E) clears the

reversing switch in the switch cup of the fan-motor assembly

(D). Position the light kit tter assembly (E) and re-install

the three screws (VV) that were removed in the rst step to

secure the light kit tter assembly (E).

CAUTION: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light xture.

NOTE: Notice the location of the fan’s slide switch. This is

the switch used to change the fan’s directional rotation.

For more information on the operation of this switch, see

Operating Your Fan on page 14.