Instructions / Assembly

Page 6 Page 3
ADDITIONAL PARTS FOR INSTALLATION (included):
4. Outlet Box
Screw (x2)
3. Universal Cross
Bar
5. Mounting Screw
(x2)
2. Wire Nut (x3)
6. Ground Screw
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION
(not included):
ADDITIONAL PARTS FOR ASSEMBLY (included):
Safety goggles Wire Strippers Flathead
Screwdriver
Phillips
Screwdriver
9. Clear glass (x3)
13. G10 Bulb 50W
max.(x3)
10. Black shade
(x3)
14. Suction Cup
11. Socket Ring
(x3)
12. Socket Ring
tool
Electrical Tape
Wire Cutters
Ladder
7. Canopy
8. Decorative Cap
(x2)
15. Gasket
INSTALLATION INSTRUCTIONS:
1. Carefully unpack the xture; Layout all parts on a clean surface.
2. Turn off power at main fuse box.
3. Install universal crossbar (3) to junction box (1) with 2 outlet box screws (4) supplied.
Make sure black and white wires of junction box (1) run through the middle opening
of the universal crossbar (3)
4. Fasten open end of ground wire (bare copper or green wire) to ground wire or ground
screw (6) of junction box (1) or ground screw (6) on universal crossbar (3).
5. Connect black wire of power supply to black wire of track and connect white wire of
power supply to white wire of track. (See Fig. 1)
NOTE: All wire connections should be made with wire nuts (2) or marrettes (included)
and pushed back into junction box (1).
6. Mount canopy of track (7) over universal crossbar (3) and mounting screws (5) then
secure with 2 decorative caps (8) supplied.