Instructions / Assembly

10
Operation
NOTE: When the heat function is used for the first time, a slight
odor may be present. This is normal and should not occur again
unless the heater is not used for an extended period of time.
NOTE: After the fireplace has been operating, when the unit is turned
off, the fan (not the heater) will continue to run for about 1 minute to
cool down the interior of the unit. During this time, you may feel cool
air from the blower outlet. This is normal and does not require any
action. The fan will stop once the interior cools down.
1
Using the Control Panel
□ Check that the heater outlet grill is not covered or
obstructed in anyway, and make sure the power to the
unit is switched on.
□ Press the appropriate button to operate your fireplace:
1
4 2
3
1. Main Power Button: This button supplies power to
all the functions of the electric fireplace. The main
power button must be in the ON position, either from
the remote or controls on the electric fireplace for the
function to work.
2. Heater Control Button: This button controls the heater
ON/OFF and 5 temperature modes from Low to High.
When the heater is first turned on, it will come on at
the lowest room temperature setting. The log set will
remember the last heat setting and in later use the
heater will start at that setting, unless power to the
unit has been interrupted. Each time the temperature
button is pressed, the temperature set point increases,
allowing you to adjust the ambient temperature.
3. Heater Locking Function: When fireplace is ON, press
the main power button (1) for 10 seconds. The heater
will be locked, and the heater control button (2) on the
control panel as well as on the remote control will be
disabled. Before the heater is locked, the flame will
flash 6 times. To unlock the heater, press the main
power button (1) for 10 seconds. Before the heater is
unlocked, the flame will flash 6 times.
4. Flame Control Button: This button controls the
brightness of the flame effect with settings at High,
Medium, and Low. When the electric fireplace is first
turned on, the flame will come on at the highest
setting. The log set will remember the last flame
setting used and in later use the flame brightness will
start at that setting, unless power to the unit has been
interrupted. Each time the flame button is pressed,
the flame brightness decreases. The only way to turn
off the flame effect completely is to turn off the main
power button (1).
Figure 2